2504 Management on VLAN

Unanswered Question
May 11th, 2012
User Badges:

We are installing a 2504 with management on VLAN2.  The management port is on interface 1 which is attached to a layer 3 3750.  From other VLANs in the network we cannot manage the 2504 controller with the web manager.  We are running the latest code, 7.2.103.0, since we are using 3600 APs.  We have a TAC case open, but spent 3 hrs with them and they can't figure out the problem.  TAC did some debugging and saw that the 2504 is ARPing for the address of the PC on the other VLAN instead of sending the packet to its default gateway.

Anyone else have success with the management interface on a VLAN and managing the controller from another VLAN?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Fri, 05/11/2012 - 20:59
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

I do it all the time. As long as you have routing from the other subnets to the management subnet, you should have no problem. Can you attach your show run-config no ap.


Thanks,


Scott Fella


Sent from my iPhone

Stephen Rodriguez Sat, 05/12/2012 - 14:23
User Badges:
  • Purple, 4500 points or more

For the other VLAN do you have interface configured on the WLC? If so:


Config network mgmt-via-dynamic-interface enable


Steve


Sent from Cisco Technical Support iPhone App

Actions

This Discussion

Related Content

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode