×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

open ports on 1841series

Unanswered Question
May 13th, 2012
User Badges:

                   Hello All



Can anyone explain a simple way of opening ports on a 1841 router




I have a working config for internet traffic. I am looking to boot up my Windows Server and Run IIS. For example i Would like to open ports for 80 www. IN a few steps can you explain.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Dean Brandt Tue, 05/15/2012 - 06:42
User Badges:

You will more than likely need to run NAT on the 1841 unless you plan to give your server a public IP address


Having sorted that you will then need to run an ACL on the outside interface that allows port 80 traffic to the server


Having said that, no ACL will allow all traffic in so make a decision re all traffic or an ACL to permit your requirements


Sent from Cisco Technical Support iPhone App

Actions

This Discussion

Related Content