jabber secure connect is not working

Unanswered Question
Feb 7th, 2012

Hi,

I set up Anyconnect on ASA5520 and  enabled secure connect in CUCM.

I did everything as written in jabber for android administration guide and end user guide.

But when secure connect configured on my mobile, secure connect entry never created even though I entered all correct parameters such as gateway address, authentication group, username and password.

ASA log says:

SVC message: 16/NOTICE: The user has requested to disconnect the connection.

SVC closing connection: User Requested.

WebVPN session terminated: User Requested.

I succeeded in connecting via Anyconnect app on iPhone.

So I believe Anyconnect Vpn connection has no problem. License checked.

Anybody succeeded in implementing secure connect using AAA authentication?

Sent from Cisco Technical Support iPad App

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mdhasan Fri, 02/17/2012 - 14:07

To isolate the issue, please check if Jabber works without ASA from inside using Wi-fi. If it does work, may be benefitial to re-post this question on the AAA /VPN/firewall side of the forum..

Thanks

Ruud van Strijp Thu, 05/31/2012 - 08:00

I have the same issue; I fill in all the settings in Jabber, but after the wizard finishes, no connections show. Jabber does work on our internal WiFi, as well as through AnyConnect VPN on my Android phone. So the issue really seems to lay in my Jabber for Android.

Any thoughts?

Actions

Login or Register to take actions

This Discussion

Posted February 7, 2012 at 5:21 PM
Updated May 15, 2012 at 6:23 PM
Stats:
Replies:3 Overall Rating:
Views:1464 Votes:0
Shares:0
Tags: No tags.
Categories: Jabber for Android
+
 

Discussions Leaderboard

Rank Username Points
1
Jonathan Schulenberg
504
2
Aaron Harrison
259
3
Chris Deren
104
4
Marcelo Almeida...
100
5
Dennis Mink
77
Rank Username Points
Marcelo Almeida...
55
Ayodeji oladipo...
10
Krzysztof Mrocz...
10
neile0001
5
Giovanni Sciotti
5