C4500 - High CPU - Supervisor II-PLUS-10GE - IOS 12.2(31r)SG3

Unanswered Question
May 22nd, 2012

We have two c4500 with above characteristics.

The cpu usage is even more higher when I apply a voice ACL on the on of the switches, more than other.

The peak is at Lopri processes.

I attached the show procc cpu and sh platform health.

When I apply a ACL the cpu utilization is 90%.

In my show log I have detected only one error duplex mismatch. The network is operating normally now, but I disabled the ACL on the other switch because than the CPU spikes. The same ACL is working fine on the other switch.

Thanks in advance.                  

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 0 (0 ratings)
frogman2010 Tue, 05/22/2012 - 02:20

I have attached another show cpu and platform output with the 70% usage. The ACL is not active, but still big usage.

The process is K2CpuMan Review and K2AccelPacketMan: Tx are using more then used to.

frogman2010 Thu, 05/24/2012 - 06:09

The proccess K2CpuMan has greatly devolved to a normal stage when I typed in the comand:

no ip unreachables on voice vlan interface

I am reading now on what are the side effects of this command.

This command stopped sending back to the cpu ICMP packets for the denied packets in the ACL.

That used a lot of cpu utilization.

Any suggestion is much appreaciated.

Actions

Login or Register to take actions

This Discussion

Posted May 22, 2012 at 12:06 AM
Stats:
Replies:2 Avg. Rating:
Views:409 Votes:0
Shares:0

Related Content

Discussions Leaderboard

Rank Username Points
1 14,997
2 8,150
3 7,720
4 7,078
5 6,710
Rank Username Points
195
80
59
57
57