×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Is there any way to know using CLI for server restart reason for CUCM

Unanswered Question
May 26th, 2012
User Badges:
Hey,

Is there any way to know using CLI for server restart reason for CUCM

If possible, i woul dlike to know if its the sam ecommand for CUCM 7, 8 & 8.6

Regards,
Shabeeb
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ayodeji Okanlawon Sat, 05/26/2012 - 01:33
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

I dont think so. Your best bet is to look at cucm logs..

Ayodeji Okanlawon Sat, 05/26/2012 - 03:59
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

You can start with RTMT--system logs...See what went wrong or what is going on there


Pls rate useful posts

Actions

This Discussion