×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How do I configure an ELAM on a 6500 running advipservices 12.2(33)SXJ

Unanswered Question
May 30th, 2012
User Badges:

Hi Guys,


I know that an ELAM can be setup on a 6500 running ipservices 12.2(33)SXJ, however I noticed that following commands are not available on a 6500 router running advipservices 12.2(33)SXJ:


show platform capture elam asic

etc


So I wanted to know if there is an alternate way to setup an ELAM for troubleshooting purposes?


Any info would be much appreciated.


thanks

Sheldon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
nkarpysh Wed, 05/30/2012 - 20:06
User Badges:
  • Cisco Employee,

Hello,


ELAM belongs to a set of hidden TS commands. Those can be enabled configuring "service internal" command in conf t mode. This command is also hidden so you need to copy paste that exactly to run.


Nik

Actions

This Discussion

Related Content