How do I configure an ELAM on a 6500 running advipservices 12.2(33)SXJ

sgonsalv · ‎05-30-2012

Hi Guys,

I know that an ELAM can be setup on a 6500 running ipservices 12.2(33)SXJ, however I noticed that following commands are not available on a 6500 router running advipservices 12.2(33)SXJ:

show platform capture elam asic

etc

So I wanted to know if there is an alternate way to setup an ELAM for troubleshooting purposes?

Any info would be much appreciated.

thanks

Sheldon

nkarpysh · ‎05-30-2012

Hello,

ELAM belongs to a set of hidden TS commands. Those can be enabled configuring "service internal" command in conf t mode. This command is also hidden so you need to copy paste that exactly to run.

Nik

HTH,
Niko