×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Which Codecs are Supported on CUCM 8.5?

Answered Question
May 31st, 2012
User Badges:

Hello Community,


Can you please assist on the above question? Is g726 supported and if yes why such a high-bitrate codec is not set as default on the CUCM settings?



thanks in advance

Correct Answer by Chris Deren about 5 years 2 months ago

From Data sheet:


http://www.cisco.com/en/US/partner/prod/collateral/voicesw/ps6788/vcallcon/ps556/data_sheet_c78-652908.html



Codec support for automated bandwidth selection:  G.711 (mu-law and a-law), G.722, G.722.1, G.723.1, G.728, G.729A/B,  Global System for Mobile-Enhanced Full Rate (GSM-EFR), Global System for  Mobile-Full Rate (GSM-FR) Internet Low Bitrate Codec (iLBC), iSAC,  wideband audio (proprietary 16-bit resolution; 16-kHz sampled audio),  and Advanced Audio codec (AAC) for use with Cisco TelePresence devices


However the codec supported between devices is driven by what the endpoint supports.

Think of G726 as old technology hence little support.


HTH,


Chris

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Chris Deren Thu, 05/31/2012 - 14:18
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

From Data sheet:


http://www.cisco.com/en/US/partner/prod/collateral/voicesw/ps6788/vcallcon/ps556/data_sheet_c78-652908.html



Codec support for automated bandwidth selection:  G.711 (mu-law and a-law), G.722, G.722.1, G.723.1, G.728, G.729A/B,  Global System for Mobile-Enhanced Full Rate (GSM-EFR), Global System for  Mobile-Full Rate (GSM-FR) Internet Low Bitrate Codec (iLBC), iSAC,  wideband audio (proprietary 16-bit resolution; 16-kHz sampled audio),  and Advanced Audio codec (AAC) for use with Cisco TelePresence devices


However the codec supported between devices is driven by what the endpoint supports.

Think of G726 as old technology hence little support.


HTH,


Chris

Actions

This Discussion