×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

MAC Sec [Switch to Switch]

Unanswered Question
Jun 2nd, 2012
User Badges:

Hi All!


My question is about deploying MacSec over L2 MAN provider.

I have HQ office and some Big office linked via MAN provider VLAN(X). Same provider provides L3 MPLS service with other VLAN(Y) for low speed far shops and offices.  Can I use MACSEC on VLANX between Cat4507+E/Sup7L-E and Cat 3560X with Service Module, when traffic passes through the other switches, and network provider could?


Thanks  All!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
hobbe Sat, 06/02/2012 - 06:28
User Badges:
  • Gold, 750 points or more

Hi


This is to my understanding not possible.

Since it is hop by hop you can not have another device between your endpoints.

(I am not sure what happens if you set a hub there.)


good luck


HTH

Actions

This Discussion

Related Content