×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SRW224G4 - How send firmware?

Unanswered Question

                   Hello,

I tried to upload the new firmware and unfortunately I turned off Swith too early. Now when I connect the serial port I did not want to end run the firmware.


xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

------ Performing the Power-On Self Test (POST) ------

UART Channel Loopback Test........................PASS

Testing the System SDRAM..........................PASS

Boot1 Checksum Test...............................PASS

Boot2 Checksum Test...............................PASS

Flash Image Validation Test.......................PASS


BOOT Software Version 1.0.2 Built  17-Aug-2006  14:55:46

:::
:::        ::: :::       ::: :::     :::::  :::::::::: :::      ::: ::::::::::
:::        ::: :::::     ::: :::   :::::   ::::     ::: ::::  :::: ::::     :::
:::        ::: ::: :::   ::: ::::::::      ::::          ::::::::  ::::
:::        ::: :::   ::  ::: ::::::::::     ::::::::::     ::::     ::::::::::
:::        ::: :::    :::::: :::    ::::            :::    ::::             :::
:::::::::: ::: :::      :::: :::      :::: :::......:::    ::::    :::......:::
......... ... ...       ... ...       .... ..........     ....     ..........

Linksys SmartSwitch based on 88E6218 with ARM946E-S.
32MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.

Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
Preparing to decompress...
100%
FAIL !!! Check image for valid file.
Please download a new image.

Downloading code using XMODEM.



Download failed

Perform WARM BOOT ...


xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx


How to re-upload the firmware?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Hi,


Yes! It.s work!


Thank you very much!


Kind Rwgards

- david.



Wiadomość napisana przez ishirshi w dniu 2012-06-04, o godz. 12:44:



Home

Re: SRW224G4 - How send firmware?

created by Ivan Shirshin in LAN, Switching and Routing - View the full discussion

Hi Dawid,


Please check this guide, page 64:


http://www.cisco.com/en/US/docs/switches/lan/csbms/srw2048/administratio...


Kind Regards,

Ivan


**Please grade this post if you find it useful.


Reply to this message by going to Home

Start a new discussion in LAN, Switching and Routing at Home


Ivan Shirshin Tue, 06/05/2012 - 10:13
User Badges:
  • Cisco Employee,

Welcome, Dawid, glad that everything is fine now! Appreciate if you could mark the correct answer and rate useful posts :-)


Kind Regards,
Ivan

Actions

This Discussion