×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Span and Rspan causes distorted voice in CCM

Unanswered Question
Jun 5th, 2012
User Badges:

Hi all,


I have the following scenario:


- one stack of 3750 , where i connect a Call Manager and a sniffer software for call recording

- one remote 3560X where i connect a voice gateway router.


The sniffer software should be able to intercept packets from CM and VG.


So i have the following config:


On stack:


vlan X

remote-vlan

monitor session 1 source interface Gi1/1 (Call Manager)

monitor session 1 destination interface Gi1/2 (sniffer)

monitor session 2 destination interface Gi1/3 (sniffer)

monitor session 2 source remote vlan X


On remote switch


vlan X

remote-vlan

monitor session 2 source interface Gi1/1 (Voice Gw)

monitor session 2 destination remote vlan X


The X vlan is transported across the trunk, all ports are in trunk mode.

I can intercept calls on the sniffer software, the problem is that when i enable monitor session 2, the incoming calls from outside became robotic and distorted.

There is not very much proccesor consumption on both switches.

Any ideas?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content