06-10-2012 06:06 AM - edited 03-04-2019 04:37 PM
Hi ,
How may modules can be plugging in cisco 2800 router .there are two uplink ports on the back of router having two internet connection from different service provider and now i have one connection for SIP ..any idea how i can connect??
Regards,
SHIB
06-10-2012 02:00 PM
What exact model? Check the below link ...
http://www.cisco.com/en/US/products/ps5854/prod_models_comparison.html
hth
MS
06-11-2012 10:03 AM
Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
Besides the exact 2800 model, what kind of media do you now use and want to expand to?
If this is Ethernet, the 2800s normally can't sustain the built-in interfaces at full bandwidth. This being so, it makes little sense to add Ethernet ports to it. If additional Ethernet ports are logically required, you can often VLAN tag them to/from the 2800.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: