×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Catalyst 3560-X Netflow

Unanswered Question

I have a couple of Cat 3560-X Switches with the 10Gig NM module installed. I want to set up some Netflow on the 10Gig Link but I can't seem to get any stats exported to the collector.


I am running 15.0(1)SE IP Base


I have the following configuration


flow record ORION-REC

match ipv4 protocol

match ipv4 source address

match ipv4 destination address

match transport source-port

match transport destination-port

collect counter bytes long

collect counter packets long

collect timestamp sys-uptime first

collect timestamp sys-uptime last

!

flow exporter ORION-EXP

destination 172.18.18.3

source Vlan2

transport udp 2055

template data timeout 60

!

flow monitor ORION-MON

record ORION-REC

exporter ORION-EXP

cache timeout inactive 30

cache timeout active 60

cache entries 1000

!

interface TenGigabitEthernet1/2

description Link to xxxxxxxxxxxxxxx

switchport trunk encapsulation dot1q

switchport mode trunk

ip flow monitor ORION-MON input

ip flow monitor ORION-MON output


Catalyst-3-DR#sho ip flow export

Flow export v9 is enabled for main cache

  Export source and destination details :

  VRF ID : Default

    Source(1)       172.18.0.3 (Vlan2)

    Destination(1)  172.18.18.3 (2055)

  Version 9 flow records

  0 flows exported in 0 udp datagrams

  0 flows failed due to lack of export packet

  0 export packets were sent up to process level


Any help would be appreciated, I have seen a few people trying to set this up but not really seen anyone have much success with this yet.


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion