06-13-2012 07:04 AM - edited 03-16-2019 11:38 AM
Is there a way to have the CME in a call forward all situation, pass the pstn ani to the external phone? I'm assuming no since it's a 2nd leg of the call ..
06-13-2012 07:15 AM
yes, under ephone-dn you can configure following commands
call-forward busy XXXX
call-forward noan XXXX timeout 10
CLID service is enabled from your telco?
06-13-2012 07:29 AM
Caller (ANI) is 512-622-1000 inbound call from PSTN to (DNIS) 512-655-9999
Call forward all has been set on extension 9999 - this forwards to 512-500-5000
When the call is forwarded - I'd like to see 512-622-1000 show up as the calling number rather than 512-655-9999
I understand that 9999 is creating a new leg of the call and I think it's operating as expected, however I'm not sure if there is a way to override it.
06-13-2012 07:43 AM
you can have a dial-peer with exact match for the destination pattern
dial-peer voice xxx pots
destination-pattern 5125005000
translation-profile outgoing
this tranlation profile will have the features to translate the calling or called numbers.
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00803f818a.shtml
06-13-2012 07:49 AM
We're talking like 100 phones who possibly do a call forward... I cant justify creating 100 dialpeers -- we have a main outgoing dialpeer that would also be matched
07-26-2012 07:20 AM
This has been resolved. Thanks
There was a translation rule hijacking the ANI
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: