06-13-2012 06:26 PM - edited 03-21-2019 05:55 AM
hi i have the UC560 with 2x 4-FXO ports.
uc500-advipservicesk9-mz.150-1.XA
I am unable to make more than 3 party conference call.
Please advise on what needs to be configured to do so. Or is it even supported?
Thanks
06-13-2012 08:10 PM
This is a supported configuration and requires that you set up hardware based conferencing on your UC560.
If this is a CCA configured box you'll need to go to configure>telephony>voice features>conference and enable multiparty conferencing.
If this is a CLI box you'll have a bit more work to do, but still fairly straight forward.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeconf.html
Cole
06-13-2012 08:55 PM
Hi. Thx for the valuable info.
I am using it as a CLI box, before I proceed to configure the hardware conference.
How can I tell that my dsp is sufficient for eg 4-5 party conference?
Currently I have 2 line card of 4port fxo. Thus a total of 8fxo lines.
Please advise
06-13-2012 09:45 PM
Hi,
You may take a look at the table No.9 for hardware conferencing and transcoding sessions in different scenarios with uc560 on the following link:
HTH,
Alex
*Please rate if helpful
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: