×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Removing ZBFW remotely

Unanswered Question
Jun 15th, 2012
User Badges:

Hello all,


I have a small branch 871 which is about 1800km away from me. I want to remove the complete ZBFW from the router (configured through SDM once) and start from scratch. Obviously I don't want to lock myself out, although there are people onsite who can reset the router in necessary, I'd like to avoid having to ask them.


Can I just do a 'no zone-member security out-zone' on the outside interface and then follow with the other 2 LAN inside interfaces?


Thanks in advance!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Quanza Support Mon, 06/18/2012 - 06:17
User Badges:

Well I'm going to answer my own question: you can just remove the 'zone-member security xxx' from the interface configuration without losing access. I did the outside first, then the 2 LAN interfaces.


Also finally came across this post: https://learningnetwork.cisco.com/thread/30212


Of course, when in doubt, a 'reload in 5' will help.

Actions

This Discussion

Related Content