cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5533
Views
0
Helpful
7
Replies

Does The SG300-10 Support RIP?

Hi!

In the CLI documentation for the SG 300 Series, it shows sh ip route rip as a command. I have installed the latest firmware and that command is no longer available. Does the SG300 series support RIP?

Thanks!

Richard S.

1 Accepted Solution

Accepted Solutions

davidagu
Level 1
Level 1

Hello Richard,

My name is David Aguilar, and I am an engineer with the Cisco Small Business Center. Thanks for writing.

The SG300 Series does not support RIP. Only static routes (maximum of 32) are supported. However, the SG500X models support the RIP version 2 dynamic routing protocol.

In regards to the new Sx300 firmware, it did add a number of impressive security features including IP ARP inspection, DHCP snooping, and SSD encryption.

All the best,

-David Aguilar

Cisco Small Business Support Center

View solution in original post

7 Replies 7

davidagu
Level 1
Level 1

Hello Richard,

My name is David Aguilar, and I am an engineer with the Cisco Small Business Center. Thanks for writing.

The SG300 Series does not support RIP. Only static routes (maximum of 32) are supported. However, the SG500X models support the RIP version 2 dynamic routing protocol.

In regards to the new Sx300 firmware, it did add a number of impressive security features including IP ARP inspection, DHCP snooping, and SSD encryption.

All the best,

-David Aguilar

Cisco Small Business Support Center

Hello,

can I ask you where can I find new 1.2.5 firmware verison? I was unable to find it.

Thank you!

Best wishes,

Marko

Marko,

The 1.2.5.70 firmware has been pulled by the business unit. Please continue to use the 1.1.2.0 firmware

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

I knew it was too good to last... Will it be added back?

Marko, please follow this post for updates;

https://supportforums.cisco.com/docs/DOC-25157

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

Thank you!

Best wishes,

Marko

Does Cisco SG300-28 support Dynamic routing in L3 mode now ? I want to check because I can see there is an update in firmware.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X