×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SRP527W Site To Site VPN

Unanswered Question
Jun 25th, 2012
User Badges:

Hi There,


I am trying to setup site-to site VPN with SRP527W firmwar (1.02)


Example:

Site A - IP Address - 192.168.1.x /24

Site B - IP Address - 192.168.2.v .24


VPN Status Showing connected. Routing table showing ipsec0 interface for remote location traffic. I can ping the remote site gateway(192.168.1.254 from 192.168.2.x range but can't ping or connect to PC connected in 192.168.1.x). I have downgraded firmware to 1.01.27 and then to 1.01.23 but no difference.

As far as i am aware, i don't need to configure any NAT or static route when VPN tunnel is up but is it something that i am doing worng?? Please help...!!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.