06-27-2012 12:22 PM - edited 07-03-2021 10:21 PM
I have a WLC 5508 with LWAP 1242 with wireless bridges connected to the APs I cannot get DHCP to pass through the bridge to the PC connected to the bridge.
Solved! Go to Solution.
06-28-2012 07:52 AM
Some third-party WGBs need to operate in non-DHCP relay mode. If problems occur with the DHCP assignment on devices behind the non-Cisco WGB, use the following commands:
–config dhcp proxy disable
–config dhcp proxy disable bootp-broadcast disable
The default state is DHCP proxy enabled.
the above commands introduced from 7.0.116.0.
06-27-2012 12:51 PM
what type of device is your wire'ess bridge? is it configured to be a universal workgroup bridge? Do you have the passive client feature enabled? (requires 7.0 code)
http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70wlan.html#wp1391015
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
06-27-2012 01:24 PM
Thanks for the reply let me update the code and i'll get back to you.
06-27-2012 04:57 PM
I turned that on that did not help the bridges are HP ProCurve M111 Client Bridge
06-28-2012 07:52 AM
Some third-party WGBs need to operate in non-DHCP relay mode. If problems occur with the DHCP assignment on devices behind the non-Cisco WGB, use the following commands:
–config dhcp proxy disable
–config dhcp proxy disable bootp-broadcast disable
The default state is DHCP proxy enabled.
the above commands introduced from 7.0.116.0.
06-28-2012 01:17 PM
That fixed it thanks for the help
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide