06-27-2012 12:22 PM - edited 07-03-2021 10:21 PM
I have a WLC 5508 with LWAP 1242 with wireless bridges connected to the APs I cannot get DHCP to pass through the bridge to the PC connected to the bridge.
Solved! Go to Solution.
06-28-2012 07:52 AM
Some third-party WGBs need to operate in non-DHCP relay mode. If problems occur with the DHCP assignment on devices behind the non-Cisco WGB, use the following commands:
–config dhcp proxy disable
–config dhcp proxy disable bootp-broadcast disable
The default state is DHCP proxy enabled.
the above commands introduced from 7.0.116.0.
06-27-2012 12:51 PM
what type of device is your wire'ess bridge? is it configured to be a universal workgroup bridge? Do you have the passive client feature enabled? (requires 7.0 code)
http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70wlan.html#wp1391015
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
06-27-2012 01:24 PM
Thanks for the reply let me update the code and i'll get back to you.
06-27-2012 04:57 PM
I turned that on that did not help the bridges are HP ProCurve M111 Client Bridge
06-28-2012 07:52 AM
Some third-party WGBs need to operate in non-DHCP relay mode. If problems occur with the DHCP assignment on devices behind the non-Cisco WGB, use the following commands:
–config dhcp proxy disable
–config dhcp proxy disable bootp-broadcast disable
The default state is DHCP proxy enabled.
the above commands introduced from 7.0.116.0.
06-28-2012 01:17 PM
That fixed it thanks for the help
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: