2504 wireless controller

Unanswered Question
Jul 2nd, 2012

They gave us a configured 2504 wireless controller to reconfigure.  I was able to login via the console and issue "show run-config" and I got the IP address for the management.  I connected an ethernet cable to laptop and gave it an IP in the same subnet but unable to ping it or access the controller via http or https.  I have also attempted via ssh and no luck.  Any idea how I can access the controller to be able to tftp a file from it.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 0 (0 ratings)
saravlak Mon, 07/02/2012 - 14:42

did you tag the management vlan of the WLC, if so untag it.

WLC>show interface summary -- check for management vlan tag.

WLC>config interface vlan management 0 -- to untag the management vlan.

Scott Fella Mon, 07/02/2012 - 14:47

Well you are able to access the wlc from the console which is a good thing. The issue might be the vlan assigned to that management interface. It might be tagged or it might be configured as a vlan id of '0' which is untagged. You need your switchport setup correctly in order to manage the wlc.

Sent from Cisco Technical Support iPhone App

Scott Fella Mon, 07/02/2012 - 14:50

Here is a good link

http://www.cisco.com/en/US/docs/wireless/controller/2500/quick/guide/ctr2504_q_s.html

Sent from Cisco Technical Support iPhone App

saravlak Mon, 07/02/2012 - 14:58

which port your laptop is connecting on the wlc, does that port mapped to management vlan only, if more than one vlan mapped to that port then the port will act as trunk port, you need switch with trunk config for uplink and access port on untagged vlan for communication or map the management interface port to one of the free physcial port.

Actions

Login or Register to take actions

This Discussion

Posted July 2, 2012 at 2:39 PM
Stats:
Replies:5 Avg. Rating:
Views:388 Votes:0
Shares:0
Tags: No tags.

Discussions Leaderboard