07-03-2012 08:45 AM - edited 03-07-2019 07:35 AM
Hello,
I currently have a network with (8) 2960 Cisco Switches. (6) of the 2960 switches are etherchanneled back to (2) 2960 switches in the computer room. I would like to setup QOS on the (8) switches, however the traffic is very differnt on each of the switches. I have video, ip phone, server, printer, PC traffic. I am not sure what the best method of separating this traffic into differnt QOS queues.
Does anybody have any suggestions or configuration examples?
07-03-2012 11:02 AM
There are only 2 software input queues and 4 output queues on each interface, so you have to group some traffic may be like
voice in priority queue--queue1
video in queue 2
server traffic in queue 3
rest of the traffic in queue 4
Siddhartha
07-03-2012 11:10 AM
Thank you for the reply,
Can you tell me what the configuration would look like on the switch for this queuing?
Thank you again
07-03-2012 12:04 PM
I am not sure whether 2960s support AutoQoS or not, if they do Configuring AutoQoS is the better way to go if they don't please check the following links for manual QoS config on LAN switches
http://www.cisco.com/en/US/products/hw/switches/ps5023/products_tech_note09186a0080883f9e.shtml
https://supportforums.cisco.com/message/3656109#3656109
https://supportforums.cisco.com/message/3636022#3636022
Siddhartha
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: