About Subnet with RV042

Answered Question
Jul 11th, 2012

Good afternoon friends...

I have RV042 Router, I'm using only one Internet conection, I'm using IP group like this 192.168.95.x, my DHCP setting use to, but in this time I have 245 workstations (may be I will have 25 additionals workstations) and some times I see IP conflict message in my current workstations.

I had read about SUBNET like response about my problem, but I'm not sure about that and how to make subnet with my RV042.

Can you give me a idea about that...?

Thank you very much.


I have this problem too.
0 votes
Correct Answer by Tom Watts about 3 years 4 months ago

Rafael, you can use any subnet you'd like such as subnet mask

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Tom Watts Wed, 07/11/2012 - 13:58

Rafael, hello.

You can navigate to setup -> network

Below is a checkbox to enable multiple subnet then you click add/edit

Add the desired subnet.

Rapha2012 Wed, 07/11/2012 - 14:07

Hello dear Thomas... Thank you for your reply...

I had using to, which should be the other IP range ? subnet mask ?

Thank you for your cooperation...


Correct Answer
Tom Watts Wed, 07/11/2012 - 14:21

Rafael, you can use any subnet you'd like such as subnet mask

Rapha2012 Wed, 07/11/2012 - 15:13

Mr. Thomas, sorry for the inconvenience...

I'm making test, with my new subnet (; subnet mask my workstations inside from new subnet has internet, mail, local system, etc... but I can't browse shared folder in workstation placed in subnet... and I can't shared folder from workstation placed in subnet to workstation placed in principal net)

I had set in local connection adapter (workstation placed in new subnet):

IP Address:

Subnet mask:

Default gateway: (I made test with, but I get same problem)

Thanks for your patience...


Tom Watts Wed, 07/11/2012 - 15:29

Rafael, this sounds like a Firewall issue on the resources you're accessing.

Rapha2012 Wed, 07/11/2012 - 16:31

Mr. Thomas, when I set old setting in local conection adapter everything is working very well. I had disable firewall in every workstation, but the problem always persists.

PD: Ping command is working fine between subnet workstations and principal net workstations...

Thank you...


This Discussion

Related Content