×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Refresh Upgrade Failed going from CUCM 7.1.5 to 8.6.2

Unanswered Question
Jul 14th, 2012
User Badges:

         I've seen other similar issues with the 'Refresh Upgrade Failed' error popping up, but can't some to find my error.  Has anyone seen this one?


"Error detected in pre-boot phase.  Unable to revert to original version.  Change in software RAID casued a hard drive reformat deleting the original version.  Recovery requires a reinstall and DRS restore of the prior working software version."


Needless to say, this sucks.  I've already done this install in my stage environment and took copious notes.  Following the Cisco directions, I installed the cop file, sftp'd the new 8.6.2 to the pyhiscal server, installed, did DRS, powered down, built new 8.6 on UCS chassis and DRS to that.  All worked as documented.  I was to the point on my production PUB where I had picked a time zone, said no to DHCP and changing the MTU size and it was 'installing packages.'  Than, BAM, install fails and throughs this error. 


Thanks for any input


Evan         

Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content