AP 1242 shows WLC's management ip as it's own ip address

Sufian allan · ‎07-15-2012

Dear All,

we are using wism 4404 code 4.2 , we are using this old code becuase of 1250 mesh APs, now when a user connect to our network and he is using intel proset software he can see details of our AP, like mac, type and AP ip address 9 which in this case it the controllers ip address) is there a way we can prevent the ap from showing it?...we will be doing an upgrade to 7.0.230 soon. will the upgrade takes care of this problem or there is a way to fix it.

thanks a lot you guys

Scott Fella · ‎07-15-2012

Disable aironet ie in the WLAN SSID advanced tab. That should do it.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Leo Laohoo · ‎07-15-2012

we will be doing an upgrade to 7.0.230 soon.

Go to 7.0.235.0 instead.

Sufian allan · ‎07-15-2012

Thanks guys for the quick reply,

i disabled the Aironet IE for the ssid, and only the AP name disappeard but not the IP address, also we have a teat controller that runs code 7.0.230 and its doing the same thing, were i can see the ip address , but not the AP name.

any fix for this.?

Thanks and regards.

Saravanan Lakshmanan · ‎07-16-2012

is the issue specific to guest wlan using anchor wlc or on all ssids.

Sufian allan · ‎07-17-2012

Hi,

Its for all SSIDs