1841 show dsl interface command

Answered Question
Jul 16th, 2012
User Badges:
  • Blue, 1500 points or more

hi all,


i'm trying to troubleshoot one of our site today and can't seem to issue the show dsl interface command on a 1841 router. could someone advise if the same command is used for SHDSL or am i running with an IOS bug? thanks in advance!


#sh dsl? 

% Unrecognized command


#sh ver

Cisco IOS Software, 1841 Software (C1841-BROADBAND-M), Version 12.4(15)T7, RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2008 by Cisco Systems, Inc.

Compiled Wed 13-Aug-08 15:42 by prod_rel_team


#sh inv 

NAME: "chassis", DESCR: "1841 chassis"

PID: CISCO1841         , VID: V05 , SN: FHK13212639


NAME: "WIC/HWIC 0", DESCR: "WAN Interface Card - ATM (With multi line G.SHDSL module)"

PID: WIC-1SHDSL-V3     , VID: V02 , SN: FOC132041KD

Correct Answer by Sandeep Choudhary about 5 years 3 weeks ago

Have you tried this:


Have  you tried this::::show dsl int atm <>

or  

                               Show controller dsl <>




Regards

Please Rate if it helps.

Correct Answer by darrenflynn about 5 years 3 weeks ago

been a while since I touched these but from memory I think its show controller dsl x/x

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
darrenflynn Fri, 07/27/2012 - 04:52
User Badges:

been a while since I touched these but from memory I think its show controller dsl x/x

Correct Answer
Sandeep Choudhary Fri, 07/27/2012 - 05:07
User Badges:
  • Purple, 4500 points or more
  • Cisco Designated VIP,

    2017 Wireless

Have you tried this:


Have  you tried this::::show dsl int atm <>

or  

                               Show controller dsl <>




Regards

Please Rate if it helps.

johnlloyd_13 Sat, 07/28/2012 - 00:21
User Badges:
  • Blue, 1500 points or more

Hey guys,


Thanks for your inputs! I think I remembered using the show controllers command but it's not there. I'll check this router again when I get back to work.


Sent from Cisco Technical Support iPhone App

johnlloyd_13 Wed, 08/01/2012 - 07:27
User Badges:
  • Blue, 1500 points or more

guess it was there all along. maybe i've got used to the show dsl int on our 800s.


#sh controllers dsl   


DSL 0/0/0 controller UP

Globespan xDSL controller chipset

Line Mode: Four Wire Enhanced

DSL mode: Trained with SHDSL Annex B

Frame mode: Utopia

Configured Line rate: 4608Kbps

Line Re-activated 0 times after system bootup

LOSW Defect alarm: ACTIVE

CRC per second alarm: ACTIVE

Line termination: CPE

FPGA Revision: 0xB3

Actions

This Discussion

Related Content