×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Busy signal with more than 2 calls on gateway

Unanswered Question
Jul 23rd, 2012
User Badges:

Hi guys,


I have a cluster with three CUCM 8.5. We're using a third-party PBX to make external calls, connected with a SIP Trunk.

Last week I installed two ISR 3925, created a new route pattern which uses our voice gateways when I call to a specific number.

The problem is that sometimes I got a busy signal.


Tried some possibilities and discovered the following:


Route Group with both gateways selected // Distribution algorithm Top Down

One call connected. When I try to start the second call I hear busy signal.

If I reverse the order of the gateways, the same problem.


Route Group with both gateways selected // Distribution algorithm Circular

Two calls connected. When I try to start the third call I hear busy signal.

If I reverse the order of the gateways, the same problem.


Route Group with one gateway selected // Distribution algorithm Top Down or Circular

One call connected. When I try to start the second call I hear busy signal.

If I select the other gateways, the same problem.


Do you have any clue?

Thank you!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gpsriramdc Mon, 07/23/2012 - 10:56
User Badges:

Hi !


Did you able debug the SIP traces in the Voice Gateway ?


You have to take care of IP trusted authentication in the Gateway as well.


Thanks

Actions

This Discussion