×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SRW248G4P management

Answered Question
Jul 24th, 2012
User Badges:

I have a SRW248G4P switch.  I would like to manage this switch.  I am sure this switch is not at factory defaults.  I have connected a laptop to the console port and the switch does not respond.  My settings are correct.  How can I reset this switch back to factory defaults?                  

Correct Answer by Tom Watts about 5 years 3 weeks ago

Hello Joe,


Unfortunately, the only way to reset the switch is via GUI or the console access. If the console is not accessible, you can call the SBSC and check the warranty status of the switch.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Davidwagman1 Tue, 07/24/2012 - 14:24
User Badges:
  • Gold, 750 points or more

Joe,


Did you check baud rate you were using? I'm drawing a blank and I'm away from the computer for a few days but maybe Tom can hop in - I think it's

38400,1,n,n.


Best,

David


Sent from Cisco Technical Support iPad App

CMBanktech Wed, 07/25/2012 - 07:17
User Badges:

Yes, I was at 38400,1,n,n.  The switch is out of warranty.  I will dispose of the switch.


Thanks for your response.

Actions

This Discussion

Related Content