cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1062
Views
0
Helpful
2
Replies

One way voice problem in cme

RAJA RAHMAN
Level 1
Level 1

HI

I have resently upgraded my cme to 8.8 & ios version isc2900-universalk9-mz.SPA.152-1.T2.binafter that on wards i am haveing problem .

from the cme setup we will dial a  speed dial and the call is routed to ccm translation patten and  from the ccm vg the call is go to pstn and it was working fine before and after upgrading  the cme the problem started .

cme side config

----------------------------------------------------------------------------------

!

dial-peer voice 4 voip

description *****FOR ACESSING HO SPEED DIAL  *****

destination-pattern *3..

session target ipv4:192.168.11.9

dtmf-relay h245-alphanumeric

codec g711ulaw

!

from this dial peer it will go to other side

-----------------------------------------------------------------------------

ccm side vg config

dial-peer voice 5003 voip

description ***** HO SPEED DIAL via PUB *****

preference 3

destination-pattern *3..

voice-class codec 1

voice-class h323 1

session target ipv4:192.168.11.4

incoming called-number .

dtmf-relay h245-alphanumeric

no vad

-----------------------------------------------------

ccm vg pots config

controller E1 1/0

framing NO-CRC4

pri-group timeslots 1-31

interface GigabitEthernet0/0

description ***** Connected to NSCC-SW1 Port 0/44 *****

ip address 192.168.11.9 255.255.255.0

duplex auto

speed auto

h323-gateway voip interface

h323-gateway voip bind srcaddr 192.168.11.9

!

interface GigabitEthernet0/1

no ip address

shutdown

duplex auto

  speed auto

!

interface Serial0/0/0

no ip address

clock rate 2000000

!

interface Serial1/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

no cdp enable

dial-peer voice 205 pots

destination-pattern 905........

fax rate disable

direct-inward-dial

port 1/0:15

prefix 05

--------------------------------------

form the cme side if call the speed dial no *360 it is translating to the original no and call is connecting

but the  called party  is not able to here  the voice  of  calling party

Please help me to resolve the issue

2 Replies 2

acampbell
VIP Alumni
VIP Alumni

Raja,

The majority of RTP one way transmission problem are down to IP routing issues.

The RTP stream should be from the CME phone ip address to the CUCM phone IP address.

In your case the issue of RTP one way direct is from CME PHONE ----> CUCM PHONE.

You weill need to start checking the IP connectivity and routing tables

from the VLAN for the CME phone to the VLAN for the CUCM phone

May be use something simple like

tracert from the CME PHONE VLAN

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.

It was a ios issue  and got resolved .

with the ios version

c2900-universalk9-mz.SPA.152-3.T1.bin

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: