08-01-2012 11:59 AM
Hi Team,
We just purchased this device and was curious if the firmware 3.0.2.0 or 3.0.1.0 has the CLI functionality like the Sx300 models with 1.1.2.0. I find it easier to configure via CLI then the WebUI.
Please advise.
Thanks for any input
08-01-2012 12:15 PM
Hello Eisada,
There is a backdoor CLI for the SGE/SFE2000/2010 switches. However, the feature is unsupported and not recommended to use. Additionally, if you enable the CLI view on the console, there is not an exit command to go back to the menu driven supported configuration.
To access this configuration you can telnet to the switch (if you enable Telnet under the Bonjour tab) or console the switch. Authenticate as you normally would.
Press ctrl+z at the same time then type LCLI and hit enter. This will toggle the CLI and a 'normal login'.
-Tom
08-01-2012 12:23 PM
I meant SGE2010.
08-01-2012 12:26 PM
My response is still valid.
-Tom
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: