i m running cme 7.1
I need to configure voice translation rule in such a way that
if the user press digit 2 it should get an outside dial tone and will be able to make an outside call.
i configured rule as below
voice translation-rule 2739025
rule 2 /^2/ /19/
voice translation-profile DirectLine1
translate called 2739025
And my dial peer is :
dial-peer voice 99999 voip
translation-profile incoming DirectLine1
dial-peer voice 9999 pots
As per my configuration when i press 2 and make an outside call the gateway gives me a fast busy tone.
but when dial 19 and outside number the call goes fine.
It seems that i am not configuring voice translation rule properly, can you please guide me how i can fix this issue.
Your consideration in this regard will be highly be comendable.
You will need to build cor-lists for that.
Here is a good doc on how to do that, it is also described well in CME admin guide as well as many other threads on this forum:
You typically do not create translation rules for such a purpose. All you need is matching dial peers and telephony-service configuration.
So, build dial-peers that match your possible routes, i.e.
dial-peer voice 1 voip
destination-pattern 2T (2 is exclusively matched so it will be stripped)
then under your telephone-service configuration add secondary-dialtone 2 to provide dial tone after user presses 2.