08-07-2012 10:45 PM - edited 03-16-2019 12:35 PM
Hi
We are wondering if exist a workaround for BootUP Automatic MCS servers when we have a power failure
Is possible to boot auto these servers?
Regards
cc
08-07-2012 11:11 PM
Hi
For MCS , I dont think we have any option to make it auto boot after power failure. You have to manaully start it.
Regards
Ronak patel
Rate helpful posts.
08-08-2012 02:09 AM
Hi CC,
We have Automatic Server restart feature [ASR] available on MCS IBM servers.This option appears in BIOS setup [u need to enter into it and enable this option].I have checked on MCS IBM servers and it works.
Please check out and let me know.
regds,
aman
08-08-2012 02:54 AM
My understanding of ASR is not that it will boot up a server that has lost power but rather, "The Automatic Server Restart event occurs when the operating system locks up and no longer responds. Subsequently, a system restart (reboot) begins."
If you've tested this though by pulling the power from a server and it did boot up again only with that setting enabled that's good to know.
08-08-2012 03:00 AM
Hi
Thnak you AMAN nad JOE for your Replies
I will check it and i will return back with a feedback
I will rate your posts if its worked
05-12-2015 01:57 AM
Hi,
have you checked the ASR feature after power failure?
05-12-2015 05:59 AM
yes it works.
after the power fails and power supply is connected with ASR set and power comes , the server boots UP
regds,
aman
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide