Multiple NAT's For Range Within 1 Subnet

Unanswered Question
Aug 16th, 2012
User Badges:

Sorry for the title, maybe a litte confusing. I wasn't sure how to title it.


Thanks for taking the time to read this.


Basically I need to create a few external ip address which translate to multiple range within our subnet.


192.168.10.1 is our subnet


I would like to have say


192.168.10.10 - 50 <----- 82.48.68.84

192.168.10.51 - 71 <----- 82.48.68.85

192.168.10.72 - 100 <------ 82.48.68.86


Is this possible using the ip nat commands?


Any ideas,


Thanks again,


Regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
BigDawgFelton Thu, 08/16/2012 - 18:20
User Badges:

I think I had a config like that where I had multiple outside interfaces and then just used my NAT statements to tell the router which IP to translate to.



As I have learned more about Cisco my first thought is now to use route maps. I think this gives you more control of where your traffic is going for each set of IP addresses.





Sent from Cisco Technical Support iPhone App

Actions

This Discussion