qsic trunk

Unanswered Question
Aug 17th, 2012

  i am trying to  configuredqsic trunk between cme and panasonic pbx.but the controller is down.here is the show command.

cme#show controllers e1

E1 0/2/0 is down.

  Applique type is Channelized E1 - balanced

  Transmitter is sending remote alarm.

  Receiver has loss of signal.

  alarm-trigger is not set

  Version info Firmware: 20100222, FPGA: 13, spm_count = 0

  Framing is CRC4, Line Code is HDB3, Clock Source is Internal.

  Data in current interval (649 seconds elapsed):

     0 Line Code Violations, 0 Path Code Violations

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 649 Unavail Secs

  Total Data (last 24 hours)

     0 Line Code Violations, 0 Path Code Violations,

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 86400 Unavail Secs

what could be the reason?

thanks

kavi

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Average Rating: 0 (0 ratings)
Chris Deren Sat, 08/18/2012 - 01:36

Try different cable and crossover.

Sent from Cisco Technical Support iPhone App

amim.ansari@ora... Sat, 08/18/2012 - 04:31

Hello,

make CME trunk as master and panasonic as salve , waht you are using here , can you paste show isdn st here . here it alos shows loss of signal , check yr cabling aprt too

rgds

Amim

      

if this helps, please rate

amim.ansari@ora... Sat, 08/18/2012 - 04:33

hi,

and make sure you use all 30 channel of E1 ,as sometime it does not worked with fragmneted channel .

rgds

AMim

      

if this helps, please rate

Actions

Login or Register to take actions

This Discussion

Posted August 17, 2012 at 8:48 PM
Stats:
Replies:4 Avg. Rating:
Views:270 Votes:0
Shares:0
Tags: No tags.

Discussions Leaderboard

Rank Username Points
1 21,051
2 15,047
3 10,325
4 8,014
5 4,856
Rank Username Points
116
105
103
76
72