08-23-2012 07:17 AM
Hi,
I have one Cisco Nexus 7K switch with 2 Sup. In that one sup should be active and anotherone should be ha-standby. But currently secondry is showing powered-up state. Earliyer also we are facing the same issue but after reload the sup the problem got resolved but the same problem occure again.
Please find the below details for same.
HJA_CS01_N7k# sh module Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
1 48 10/100/1000 Mbps Ethernet XL Module N7K-M148GT-11L ok
3 48 10/100/1000 Mbps Ethernet XL Module N7K-M148GT-11L ok
4 8 10 Gbps Ethernet XL Module N7K-M108X2-12L ok
5 0 Supervisor module-1X powered-up
6 0 Supervisor module-1X N7K-SUP1 active *
7 8 10 Gbps Ethernet XL Module N7K-M108X2-12L ok
8 48 10/100/1000 Mbps Ethernet XL Module N7K-M148GT-11L ok
10 48 1000 Mbps Optical Ethernet XL Modul N7K-M148GS-11L ok
Mod Sw Hw
--- -------------- ------
1 5.2(1) 1.2
3 5.2(1) 1.2
4 5.2(1) 1.4
6 5.2(1) 2.1
7 5.2(1) 1.4
8 5.2(1) 1.2
10 5.2(1) 1.3
Kindly suggest why its going in powered-up mode in after every 1-2 Months.
08-23-2012 11:13 AM
Check if there is coredump file using show core command and export to tftp/scp/ftp server.
check comamnd "show system redundancy status". Call Cisco TAC or partner support when you encounter issue again and collect tac-pac.
08-23-2012 06:48 PM
Duplicate post #1.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: