×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

IPS question for ASA 5525-X's

Unanswered Question
Aug 29th, 2012
User Badges:

I am used to dealing with the separate SSM-10,20 or 40 modules that go in the non-X version of the ASA's.  In those, even in an active standby configuration, you had to individual configure each IPS sensor (even on the standby unit) since the IPS configuration wasnt synchronized between ASA's like the ASA configuration is.


Is the IPS configuration now a part of the 5525-X config or will I still be looking at configuring the IPS separately like I am used to doing ?


Ron                  

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Julio Carvajal Wed, 08/29/2012 - 13:09
User Badges:
  • Purple, 4500 points or more

Hello Ronald,


It needs to be done on the same way, no replication between IPS modules,


Regards,


Remember to rate all the helpful posts


Julio

Actions

This Discussion

Related Content