cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1366
Views
0
Helpful
3
Replies

TMS - Endpoint SNMP Traphost Address

Patrick Sparkman
VIP Alumni
VIP Alumni

Should I see the SNTP traphost address field under the "Settings" view for a C-Series, EX, E20 endpoints that are managed by TMS?  Is it okay to leave this field blank or should it contain the IP or DNS address of TMS, in conjunction with the SNTP settings on the endpoint itself?

Thanks, Patrick

2 Accepted Solutions

Accepted Solutions

mahkrish
Level 3
Level 3

Hi Patrick, For Endpoints that Cisco TMS uses SNMP to communicate with, the Traphost IP Address is also set. This is done automatically on all systems if the Enforce Management Settings on Systems is enabled in Network Settings > Cisco TMS Service pane.

View solution in original post

Hi Patrick,

All SNMP traps from TC and TE software systems are ignored by TMS, so you can safely leave these fields blank.

-Kjetil

View solution in original post

3 Replies 3

mahkrish
Level 3
Level 3

Hi Patrick, For Endpoints that Cisco TMS uses SNMP to communicate with, the Traphost IP Address is also set. This is done automatically on all systems if the Enforce Management Settings on Systems is enabled in Network Settings > Cisco TMS Service pane.

I take it the C-Series, EX, and E20 doesn't use SNMP, since they communicate over HTTP/HTTPS?

Hi Patrick,

All SNMP traps from TC and TE software systems are ignored by TMS, so you can safely leave these fields blank.

-Kjetil

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: