Dear all,
my newly purchased 886VAW won't sync.
The link ( ISDN ) I'm running it off from runs nicely on my crusty-trusty 803. I linked the box
with the cables supplied against the splitter as usual but can't seem to get a stable CD light ( constantly flashing ).
The box is intended to run against ADSL (with VDSL to come in a few days ).
Can someone shed some light on what I am doing wrong ?
Controller VDSL 0 is DOWN
Daemon Status: Establishing Link
XTU-R (DS) XTU-C (US)
Chip Vendor ID: 'BDCM' 'IFTN'
Chip Vendor Specific: 0x0000 0x71B8
Chip Vendor Country: 0xB500 0xB500
Modem Vendor ID: 'CSCO' ' '
Modem Vendor Specific: 0x4602 0x0000
Modem Vendor Country: 0xB500 0x0000
Serial Number Near: C886VA-W 15.1(4)M
Serial Number Far:
Modem Version Near: 15.1(4)M
Modem Version Far: 0x71b8
Modem Status: Idle
DSL Config Mode: AUTO
Trained Mode:
TC Mode: UNKNOWN
Selftest Result: 0x00
DELT configuration: disabled
DELT state: not running
Trellis: OFF OFF
Full inits: 0
Failed full inits: 11
Short inits: 4
Failed short inits: 6
Firmware Source File Name (version)
-------- ------ -------------------
VDSL embedded VDSL_LINUX_DEV_01212008 (1)
Modem FW Version: 110506_1916-4.02L.03.B2pvC032b.d23i
Modem PHY Version: B2pvC032b.d23i
Training Log : Stopped
Training Log Filename : flash:vdsllog.bin
sho run int ATM0:
interface ATM0
no ip address
atm vc-per-vp 64
no atm ilmi-keepalive
end
interface ATM0.1 point-to-point
no ip redirects
no ip unreachables
no ip proxy-arp
ip flow ingress
pvc 1/32
pppoe-client dial-pool-number 2
!
end
