cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
3205
Views
0
Helpful
1
Replies

How to load a boot image to cisco aironet 1140 series after missing boot image

Hi all,

I need a solution for this. When i switch my cisco aironet 1140 , it s blinking with red light .and gives a message "no boot image to load".

When i tried next time, by pressing escape it shows this message that i have mentioned below.

ap:

ap:

using  eeprom values

WRDTR,CLKTR: 0x83000800 0x40000000

RQDC ,RFDC : 0x80000035 0x00000208

using ĆæĆæĆæĆæ ddr static values from serial eeprom

ddr init done

Running Normal Memtest...

Passed.

IOS Bootloader - Starting system.

FLASH CHIP:  Numonyx P33

Checking for Over Erased blocks

................................................................................                                                                             ................................................................................                                                                             ................................................................................                                                                             ......

Xmodem file system is available.

DDR values used from system serial eeprom.

WRDTR,CLKTR: 0x83000800, 0x40000000

RQDC, RFDC : 0x80000035, 0x00000208

PCIE0: link is up.

PCIE0: VC0 is active

PCIE1: link is NOT up.

PCIE1 port 1 not initialized

PCIEx: initialization done

flashfs[0]: 1 files, 1 directories

flashfs[0]: 0 orphaned files, 0 orphaned directories

flashfs[0]: Total bytes: 32385024

flashfs[0]: Bytes used: 1536

flashfs[0]: Bytes available: 32383488

flashfs[0]: flashfs fsck took 16 seconds.

Reading cookie from system serial eeprom...Done

Base Ethernet MAC address: 28:94:0f:d6:c8:62

Ethernet speed is 100 Mb - FULL duplex

The system is unable to boot automatically because there

are no bootable files.

C1140 Boot Loader (C1140-BOOT-M) Version 12.4(23c)JA3, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Compiled Tue 18-Oct-11 14:51 by prod_rel_team

ap:

So , now my question is how to load the boot image ? From where will we get this ? OR

I m also having another Cisco aironet 1140 , Can i get bootimage from that . Kindly let me know the solution from genius ?

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

Take a look at this link as it should have the info you need

https://supportforums.cisco.com/docs/DOC-14636

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: