10-09-2012 07:53 AM
Hi,
I have to do a bootflash defragmentation on CRS-3. I already have a procedure but I have a question about the FP-140 cards. As I could see the RP, MSC and FP40 have a bootflash, but I´m not sure if FP-140 has a bootflash.
I ask this because when I apply the show command to check fragmentation state in each FP140 card I get the following error:
0/0/CPU0 FP-140G 14-10GbE IOS XR RUN PWR,NSHUT,MON
RP/0/RP0/CPU0:CRS#show filesystem bootflash: filesys location 0/0/CPU0 | include Stale
Mon Oct 1 16:56:10.115 SCHILE
Unable to open file : No such file or directory
But when I apply the command to another type of card I can see the % of fragmentation:
0/2/CPU0 MSC 8-10GbE IOS XR RUN PWR,NSHUT,MON
RP/0/RP0/CPU0:STGO-LACI-P1#show filesystem bootflash: filesys location 0/2/CPU0 | include Stale
Mon Oct 1 16:56:29.454 SCHILE
Stale : 25896652 Bytes 41%
I hope that somebody could help me.
Thanks,
Jaime.
10-10-2012 01:54 PM
Hi Jaime,
Every SP node has a bootflash.
I would recommend using the show filesystem bootflash: all location 0/0/CPU0 command from admin mode in order to see all the information
Regards,
Sam
10-15-2012 12:26 AM
Hi Jaime, Sam,
no more SP in the CRS-3 line cards (FP140...), all the environmental monitoring is done by an embedded board now.
The bootflash has been replaced by a eUSB of 4GB in the card (lcdisk0: and lcdisk0a:). You don't need to defrag it.
Cheers,
N.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: