Problems with SPA122

remnts · ‎10-12-2012

I have trouble setting up my ATA Spa 122, I can not access the web settings, I have connected my PC on the same LAN, I can only enter the Web-based Utility from the Ethernet port of the ATA.

You can set for example if my PC has IP 192.168.1.3 and 192.168.1.8 IP ATA has a?

thanks

nseto · ‎10-15-2012

The WAN side access is off by default. In the IVR, you can enter 7932 and then 1 to enable access. Also this should be changeable in the router config of the web UI when you access it via the LAN initially.

love.cavaliers1 · ‎12-12-2015

I tried the 7932 and it is an invalid response.

Stephan_Rackco · ‎04-27-2019

This problem was kicking my butt as well...

The answer is simple and frustrating... The IVR will not allow the use of 7932# option when the default password is still in place.

The fix...

1) Connect WAN to Internet port
2) Connect any PC/Laptop to the Ethernet Port ( make sure your device is set to get a DHCP address )

3) The Cisco ATA 122 will assign your device an IP ( typically 192.168.15.100 )

4) Open a browser on your PC/Laptop and go to http://192.168.15.1 and login with default user/pass which is admin/admin

5) In configuration menu change default admin pass to a new password, while you are here enable WAN admin access.

6) For sheets and giggles and to see I wasn't pulling your leg, check the IVR again, 7932# will work now! DOH!