×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

UC540 Voicemail Mailboxes

Answered Question
Nov 8th, 2012
User Badges:

On our UC540, we have set a couple of numbers for Single-Number Reach to call our Cisco Jabber enabled iPhones. Since they are a different extension than our primary extension, the voicemail box is a different mailbox that the primary number called, i.e. my main desk extension is 301 and my SNR for my Jabber is 321. How can I get extension 321 to go to voicemail-box for extension 301?

Correct Answer by paolo bevilacqua about 4 years 9 months ago

Make sure that no-answer timeout in snr command is shorter than the one on the SNR other extension..

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
paolo bevilacqua Thu, 11/08/2012 - 09:30
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

When you configure SNR, you can configure voicemail number and timeout for no answer. Theephone-dn number mailbox will then be activated in all cases.

nshoe18 Thu, 11/08/2012 - 09:46
User Badges:

We tried that and it would ring through but then the system seemed to point to the voicemail box for the 321 extension as it said there is no mailbox setup for this extension.


Here is a screenshot of my setup.


Correct Answer
paolo bevilacqua Thu, 11/08/2012 - 12:59
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Make sure that no-answer timeout in snr command is shorter than the one on the SNR other extension..

Actions

This Discussion