I apologize if this is in the wrong place as it is a decidedly newbie question but I can't find an answer anywhere here. I am trying to connect my SPA122 ATA to my new TP-Link TL-WDR3600 wireless router. This setup worked with my old router (NetGear WGR614) but I cannot seem to get it to work with the new router. I am connected to the Internet through a Huawei MT130U cable modem with nominal 28MBS bandwidth. I have been told that the throughput of the router in the SPA122 would restrict that so I had connected it to my old WLAN router in the DMZ. This worked fine before but not with new router.
TP-Link TLWDR3600 N600 Dual Band Gigabit Router. DHCP range: 192.168.0.100-199 and I reserved 192.168.0.150 for the MAC address of the SPA122. I set 192.168.0.150 as the DMZ host IP and enabled it.
SPA122: I set the Networking Service to Bridge. I have tried using both Automatic DHCP and Static IP. Neither seem to work.
Static IP address: 192.168.0.150 Subnet Mask: 255.255.255.0 Default Gateway: 192.168.0.1 (discovered by IPCONFIG)
Any help or assistance would be most gratefully received. Thank you.