891-W router with embedded AP

Unanswered Question
Dec 27th, 2012
User Badges:

Hi, this router is a great solution in my house, but I do not understand where in the CCP I can configure PAT for communication back 7960G VoIP phone with SIP firmware

Maybe I'm wrong on the concept of communication pass back to the Voice VLAN, someone can help me understand what I should do?

Best Regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Alex Alvarez Sun, 12/30/2012 - 08:39
User Badges:



This document say how, in this point only you need deactivate native sip as service and specify range ports to nat :


ip nat portmap SIP


no ip nat service sip udp port 5060

no ip nat service allow-sip-even-rtp-port

ip nat inside source list 1 interface Dialer0 overload portmap SIP

ip route Dialer0




This Discussion

Related Content