UCSM via SSH but not HTTP(s)

Ryan · ‎01-02-2013

I cannot load the webpage for my UCS via the cluster IP which was working before a full power down. I can SSH to the cluster IP and see things, but the web site and the GUI aplpication no longer work. I tried a second power cycle to no avail and I have gone in to disable / enable the http and https services, again to no avail.

I'm lost as what might be wrong.

-Ryan

kg6itcraig · ‎01-02-2013

Did you try your two FI IP's? You should be able to connect to the active one. Try each, which ever works is active, the other will say it isn't active.

Make sure your http/s options didn't change once up.

My UCS Blog http://realworlducs.com

abbharga · ‎01-02-2013

Hi Ryan,

Since you can SSH to the UCSM, can you also connect to the local-mgmt of both the FIs and run the following command to make sure the HTTP service is running

FI-A(local-mgmt)# show pmon state

Sample good outout

BGL-SV-UCS-TEST-B(local-mgmt)# show pmon state

SERVICE NAME STATE RETRY(MAX) EXITCODE SIGNAL CORE

------------ ----- ---------- -------- ------ ----

svc_sam_controller running 0(4) 0 0 no

svc_sam_dme running 0(4) 0 0 no

svc_sam_extvmmAG running 0(4) 0 0 no

httpd.sh running 0(4) 0 0 no <<<<< running service

svc_sam_sessionmgrAG running 0(4) 0 0 no

Make sure to check this on both the FI.

./Abhinav