×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Phone registers but will not pull specific load

Unanswered Question
Jul 3rd, 2013
User Badges:

I have a phone that is registering with my CM but will not pull specific configuration file for the phone.. I.E. will not pull button configs or DN.



Basic Setup..

    Static IP on phone

    Voice VLAN

    IP Routing in place (0.0.0.0 xxx.xxx.xxx.xxx) generic route to point everything to next hop


Phone shows:      CTL Installed

                          SEP(MAC).cnf installed               


CM Shows phone resigered



From what I can see the phone is configured correctly (was tested in a serperate location and registered correctly and was able to place test call with no issues) and CM is good.


What should I look for in the network?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
yahsiel2004 Wed, 07/03/2013 - 20:43
User Badges:
  • Gold, 750 points or more

Try deleting the CTL file on the phone.

Actions

This Discussion

Related Content