Here's the checking from our client below:
1. Single tag at PE and no tag at CE
2. Single tag at PE and single tag at CE
If using 1., then PE can see CE MAC, but CE still cannot see PE MAC, thus, CE & PE cannot ping each other,
If using 2., then PE and CE cannot see MAC of each other, thus, CE & PE cannot ping each other.
Currently, PE is setting double tag & CE is setting single tag as following. Both cannot see each other MAC.
Please further check it.
PE router:
ME2# run show configuration interfaces ge-5/2/0.10
vlan-tags outer 910 inner 910;
family inet {
mtu 1500;
no-redirects;
address 10.185.0.133/30;
}
{master}[edit]
ME2# run show arp | match 5/2/0.10
{master}[edit]
CE router:
Router(config-subif)#do show run | s GigabitEthernet0/0
interface GigabitEthernet0/0
description link to PE: DTAC to update circuit ID
bandwidth 4000
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
load-interval 30
duplex full
speed 100
no cdp enable
hold-queue 32768 out
interface GigabitEthernet0/0.910
encapsulation dot1Q 910
ip address 10.185.0.134 255.255.255.252
no cdp enable
PHSDCOTAUPH01R02(config-subif)#do show arp
Protocol Address Age (min) Hardware Addr Type Interface
Internet 10.185.0.133 0 Incomplete ARPA
Internet 10.185.0.134 - 0006.f6e8.8970 ARPA GigabitEthernet0/0.910
What's next course of action for this? thanks
