Change default password on LAP?

Answered Question
Jul 15th, 2013
User Badges:

I have several new 2602e access points configured on two 4408 WLCs. All went surprisiongly well with the installation and configuration. However, I want to change the default user and password, but I'm not sure where to do this from. There doesn't appear to be a configure command in enable mode on the APs and I can't find where the user accounts might be controlled from the controller.


Anyone know the answer?


Thanks!

Correct Answer by Scott Fella about 4 years 1 month ago

Here is where you would change it.  You would also have to enable ssh or telnet on each AP



Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Scott Fella Mon, 07/15/2013 - 12:24
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Here is where you would change it.  You would also have to enable ssh or telnet on each AP



Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

Daniel Ordonez Mon, 07/15/2013 - 13:31
User Badges:
  • Gold, 750 points or more
  • Participante Destacado,

    El Favorito: Noviembre 2015

Hello Scott.


One questions when you set up an username & password the changes are apply to all AP's ?

kmkrause2 Mon, 07/15/2013 - 12:34
User Badges:

Worked like a charm. Thanks for the prompt reply. I must have passed over that page a dozen times. The light just never went on, I guess

Scott Fella Mon, 07/15/2013 - 12:36
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Yeah or else its the default Cisco/Cisco.

Sent from Cisco Technical Support iPhone App

Abhishek Abhishek Mon, 07/15/2013 - 15:21
User Badges:
  • Gold, 750 points or more

Hello Sali,


As per your query i can suggest you the following solution-


To change the default user and password. It can be done under wireless tab then go to global configuration.


Hope this will help you.

Actions

This Discussion