×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Etherchanel question

Answered Question
Jul 16th, 2013
User Badges:

EtherChannel.jpg

Is this topology posible?


I would like to connect a stack of Cisco 2960S switches to two 4500X switches using etherchannel for redundancy. I have tried different methods but none of them work. The 4500X switches are not stacked (I don't think it is possible thou).


Thanks in advance!

Correct Answer by Reza Sharifi about 4 years 1 month ago

It is not possible unless you use VSS on the 4500X.


HTH

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
Reza Sharifi Tue, 07/16/2013 - 19:42
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

It is not possible unless you use VSS on the 4500X.


HTH

Kryztian7 Wed, 07/17/2013 - 05:47
User Badges:

Thanks a lot for your replies.


I guess VSS is the way to go.


Thanks!

InayathUlla Sharieff Tue, 07/16/2013 - 19:44
User Badges:
  • Cisco Employee,

As Reza said this one only be achieved using VSS or VPC in Nexus technology.


Regards

Inayath

Actions

This Discussion