04-07-2011 03:46 AM - edited 03-06-2019 04:29 PM
<Deleted>
04-07-2011 05:15 AM
Dennis,
Can you change the Cisco side to LACP passive and Juniper to active?
also, can you post your Juniper config?
Reza
04-07-2011 07:27 AM
With LACP configuration and Error: pagp_switch_is_in_port_channel: , I see this as a transient issue. Try reloading the switch.
Pls vote if you think the post was helpful.
Regards,
Sunil
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
